I started running the finishing toolpaths on the Pocket NC today.
I'm disappointed with how the flow toolpaths turned out when cleaning up those chamfered edges, the machine had this weird pausing as if it was stalling (it wasn't) and left some pretty lousy finish marks. Maybe I programmed it wrong, and there is some smoothing I forgot to enable but very unhappy with that toolpath, I may try it again with swarf as I got great results when finishing the inside pockets.
The swarf toolpaths for the side pockets turned out surprisingly well, and I got a very decent surface finish on all of them. I used a 1/8" endmill but should have gone with the 1/16" as it can't quite reach those corners, meaning it left some material there and looks a bit off if you study it.
I also cut out three of the final features using a 1/16" square endmill and a contour toolpath ramping down. Still not sure how to get that last feature at the top where it slopes into the top pocket (see picture above), and any suggestions would be much appreciated!